Wound Beads (2944666634)
44 WOUND BEAD
Broadband Frequencies 1-200 MHz (44 material)
Printer Friendly Data Sheet
Part Number: 2944666634
44 WOUND BEAD
Explanation of Part Numbers:
– Digits 1 & 2 = Product Class
– Digits 3 & 4 = Material Grade
– Last digit 1 = Bulk Packed 4 = Taped and Reeled
Six and eleven hole beads, in two NiZn materials, are available both as beads (product class 26) and wound with tinned copper wire in several winding configurations (product class 29).
Wire used for winding is oxygen free high conductivity copper with 100% matte tin plating over a nickel undercoating.
Recommended storage temperature and operating temperature is -55 °C to 125 °C
– Parts with a 1 as the last digit of the part number are supplied bulk packed. Wound beads with part numbers 29–666631 and 29–666651 can be supplied radially taped and reeled per IEC 60286-1 and EIA 468-B standards. For these taped and reeled wound beads the last digit of the part number is a 4. Taped and reeled wound beads are supplied 500 pieces on a 13 reel.
For any wound bead requirement not listed in here, please contact our customer service group for availability and pricing.
Weight: 1.4 (g)
|Dim||mm||mm tol||nominal inch||inch misc.|
|Turns Tests||Wire Size||1st Wire Length||2nd Wire Length|
|Tape Width mm||Pitch mm||Parts 7" Reel||Parts 13" Reel||Parts 14" Reel|
+ Test frequency
•A ½ turn is defined as a single pass through a hole.
|Typical Impedance (Ω)|
Beads are controlled for impedance limits only. Minimum impedance values are specified for the + marked frequencies.
The minimum impedance is listed on our catalog drawing.
The 44 material beads and wound beads are tested on the E4990A Impedance Meter. The 61 material parts on the E4991A / HP4291B Impedance Analyzer.
|Typical Impendance (Ω)|
A NiZn ferrite developed to combine a high suppression performance, from 30 MHz to 500 MHz, with a very high DC resistivity.
Available in 44 material:
Round Cable Snap-Its
Connector EMI Suppression Plates
44 Material Characteristics
|Initial [email protected] B < 10 gauss||µi||500|
|Flux Density @ Field Strength||Gauss
|Residual Flux Density||Gauss||Br||1100|
|Loss Factor @ Frequency||10 -6
|Tan δ/ µi||150
|Temperature Coefficient of Initial Permeability (20 -70°C)||% / °C||1.6|
**** Characteristic curves are measured on standard Toroids (18/10/6 mm) at 25°C and 10 kHz unless otherwise indicated. Impedance characteristics are measured on standard shield beads (3.5/1.3/6.0 mm) unless otherwise indicated.
Material Safety Data Sheet (MSDS)
Click here to download Complex Permeability vs. Frequency (CSV)
Ferrite Material Constants
Storage and Operating Temperature
Printer Friendly Data Sheet - Download as pdf file